AGCO / Massey Ferguson Error Code F0300 — What It Means and How to Fix It

Applies to: MF 7714, MF 7718, MF 7722, MF 7726, MF 8727, MF 8730

MF F0300AGCO / Massey FergusonManually verified

Hydraulic System — Charge Pressure Low

Hydraulic charge pressure is below the required operating level. Three-point linkage and remote valves may be sluggish or non-responsive.

Repair difficulty

Workshop recommended

Repair time

2h

Dealer cost

$600-3000

Likely causes

  1. 1

    Low hydraulic fluid level— Most likely

    Check the sight glass on the rear axle housing. On MF 7700/8700, the hydraulic system shares fluid with the transmission and rear axle.

  2. 2

    Blocked hydraulic suction strainer— Possible

    The internal suction strainer rarely needs attention but can block if contaminated fluid has been used or a component has failed internally.

  3. 3

    Worn hydraulic charge pump— Possible

    The pump gears wear gradually. A useful test: pressure should recover quickly when the engine revs increase. Slow recovery under increasing RPM suggests pump wear.

Parts needed

Tools needed

  • hydraulic pressure test kit
  • drain pan
  • MF Massey 1135 fluid or equivalent

Want alerts when we add new codes? Drop your email.

Look up another code